installing remote bleeder lines

[SLPRedGTO]

does anyone have advice on putting in hendricks SS remote bleeder lines the efficient less hecktick way, with the least chance of messing something up

[Poolshark1321]

The speed bleeder install requires you to pull the transmission and then remove the old bleeder valve connected to the slave cylinder. Most people separate the transmission from the bell housing instead of trying to disconnect the bell housing first. The bolts to disconnect the bell housing are much harder to get with the transmission. So its much easier to take it out in 2 pieces.

You do this step when dropping the transmission for a clutch swap so its common to do it all at once. Just remember that the slave cylinder is inside the bell housing slipped around the spline of the transmission. There clutch line and bleeder line will actually run inside the bell housing through a small hole that is close to the slave cylinder.

Here are some good clutch installs that you can look at to help you get a better idea of what process you will need to go through.

Kingsize's Drivetrain Upgrade - http://www.gastiresoil.com/showthread.php?t=48

My Clutch Install - http://www.gastiresoil.com/showthread.php?t=1456&page=2